How to Change charging Connector for Huawei Y6 2019
Your life is interrupted by facing the charging problems. It will irritate you at the highest level. The user has tried dozens of Micro USB cables and the problem persists. The Huawei Y6 2019 charging problem. It either detects your load or backs up the data. The main concern is that you cannot charge your smartphone.
The guide will explain how to replace the fault Huawei Y6 2019 charging connector. All the steps are explained with details to accompany during your smartphone repair
Before starting a repairing of Huawei Y6 2019 charging port. We highly recommended you to make a full backup of the data as a precaution.
If your USB port is fully damaged or clogged because of some problems.
Huawei charger is not recognized.
Huawei charging could not detect
Huawei Y6 is not able to recognise when it is connected to the computer.
Facing the charging issues.
Turn off your smartphone:
Before fixing the problems of the Huawei Y6 2019 charging connector, you must switch off your smartphone because of the security reasons.
You press On/off button on the right side for the few second
Insert the extraction tool
You can insert an extraction tool in the tool kit and make a small hole of the Sim Drawer on the left edge.
Just put a small pressure and the Sim Tray eject itself. So, you can easily remove it.
Extract the SIM & SD card:
Now you can extract SIM and SD cards in less than two minutes.
Gently slide the spatula between the top and bottom of the screen to give leverage and create a slight gap for opening
Unclip both sides:
Continue to unclip both sides from the front and backside shell. The backside is firmly clipped. Do it gradually.
You can gently remove half from the chassis.
Your back cover is separated now.
Take the screwdriver from the tool kit to unscrew the 3 screws circled. Remove the metal cover by using the plier and remove the Metal cover by using the pliers. The protective metal plate is removed
Unlock the battery:
You can use the Nylon Spatula to unlock the battery.
Note: The precaution measure should be taken to prevent from the short circuit during the repairing of the Huawei Y6 2019
Using the screwdriver, unscrew the 7 screws.
Gently extract the external Speaker:
The external speaker is now disassembled.
Reuse the Nylon spatula to disconnect the bonding layer on the charging connector Side.
Charging Connector Side:
You can use the Nylon Spatula to disconnect the bonding layer on the charging connector side.
Keep the Nylon spatula in your hand to disconnect the interconnection cable.
Dislodge the charging connector:
The back to interfere under the charging connector to gently dislodge it.
Your Huawei Y6 2019 charging connector is disassembled.